Hiberg RFC-400DX NFGB inverter

Данная инструкция на русском языке предназначена для холодильника Hiberg RFC-400DX NFGB inverter, описывает принцип работы и основные моменты эксплуатации устройства. Перед первым включением рекомендуется внимательно изучить данное руководство.

Инструкция для холодильника представлена в формате PDF, который поддерживается на всех современных устройствах, так что сложностей с открытием файла возникнуть не должно. Но если открыть документ не получается, установите любую программу для чтения PDF файлов, например Acrobat Reader.

Чтобы распечатать инструкцию, нужно ее сначала скачать, для этого кликните по кнопке «Скачать инструкцию», файл откроется в новой вкладке, затем нажмите комбинацию клавиш Сtrl + P и из открывшегося диалогового окна, отправьте документ на печать.

Страницы: Стр:
30
chased, keeping all the packaging ma-
terials.
Before plugging in the refrigerator, it
is recommended to wait about 4 hours
to return the refrigerant agent back into
compressor.
Before connecting the refrigerator to
the power supply, make sure that the
power supply parameters correspond
to the parameters indicated on the
technical label. It is located either on
the back wall, or on the left or right in-
ner wall of the product.
The refrigerator can only be con-
nected to a single-phase AC 220~240
V/50 Hz. In case of frequent voltage
surges, it is recommended to use a
voltage stabilizer with automatic ad-
justment.
The power in the outlet must cor-
respond to the parameters of the prod-
uct. The outlet must grounded. It is
recommended to use a separate outlet
to which other electrical appliances will
not be connected. Do not use extended
cord. Make sure that plug and power
cord are not damaged. Otherwise,
it can lead to a short circuit, electric
shock, overheating and even re.
When you turn on the refrigerator
for the rst time, do not ll it with food
immediately. Let it reach the necessary
temperature for 2-4 hours.
ATTENTION!
If it is necessary to perform any pro-
cedures with the refrigerator (mov-
ing, cleaning, etc.), rst disconnect
the refrigerator from the power sup-
ply. Once nished, plug in the refrig-
erator. When unplugging the refrig-
erator from the wall outlet, always
hold on to the plug.
Do not pull the power cord.
If the refrigerator is disconnected
from the power supply, the subsequent
connection to the network should be
made no earlier than 10 minutes later.
Failure to comply with this rule may
lead to the failure of the compressor.
Do not use the refrigerator in the
absence of a lampshade/lid on the in-
terior lighting lamp.
Any electrical component can only
be replaced or repaired by a certied
service representative. In this case,
only original spare parts should be
used.
Do not store other electrical appli-
ances, such as ice cream machines,
inside the refrigerator unless it is ap-
proved by the manufacturer.
Refrigerant and risk of re
The refrigerator contains a small
amount of refrigerant (R600a) in the
refrigeration circuit.
Since the refrigerator contains
R600a refrigerant, which is safe for the
environment, but has a high combus-
tibility, make sure that the refrigerant
tubes are not damaged during trans-
portation and installation. Leakage of
the refrigerant can lead to a re. If a
refrigerant leak has already occurred
in order to avoid re and eye damage,
remove lit candles, lamps and other ob-
jects with an open flame or high tem-
perature away from the refrigerator and
thoroughly ventilate the room. Do not
store flammable items (such as sprays,
aerosols, or explosives) in the refrigera-
tor. The room area should be at least 1
m3 per each 8 g of refrigerant (R600a).
The amount of refrigerant in the refrig-
erator is indicated on the rating label.
Страницы: Стр: 27
Комментарии (0)

Добавить комментарий

Другие Холодильники Hiberg