Tefal X-plorer Serie 60 RG7447WH

Данная инструкция на русском языке предназначена для пылесоса Tefal X-plorer Serie 60 RG7447WH, описывает принцип работы и основные моменты эксплуатации устройства. Перед первым включением рекомендуется внимательно изучить данное руководство.

Инструкция для пылесоса представлена в формате PDF, который поддерживается на всех современных устройствах, так что сложностей с открытием файла возникнуть не должно. Но если открыть документ не получается, установите любую программу для чтения PDF файлов, например Acrobat Reader.

Чтобы распечатать инструкцию, нужно ее сначала скачать, для этого кликните по кнопке «Скачать инструкцию», файл откроется в новой вкладке, затем нажмите комбинацию клавиш Сtrl + P и из открывшегося диалогового окна, отправьте документ на печать.

Страницы: Стр:
42 43
5.
IS THERE A PROBLEM WITH YOUR APPLIANCE?
According to model:
The charger is getting hot:
4 This is perfectly normal. The vacuum cleaner can remain permanently connected to the charger
without any risk.
The charger is connected but your appliance is not charging:
- The charger is incorrectly attached to the appliance or is faulty.
4 Check that the charger is properly connected or contact an Approved Services Centre to change
the charger.
Your appliance stops during use:
- Your appliance may be overheating.
4 Stop the appliance and leave cool for at least 1 hour.
4 If it overheats on repeated occasions, contact the Approved Services Centre.
The appliance stopped after the charge light was ashing:
- The appliance has run out of battery charge.
4 Recharge the vacuum cleaner.
The power-brush is not working properly or makes a noise:
- The rotating brush or hose are obstructed.
4 Stop the vacuum cleaner and clean them.
- The brush is worn.
4 Contact an Approved Service Centre to change the brush.
- The belt is worn.
4 Contact an Approved Service Centre to change the belt.
The power-brush stops during vacuuming:
- The safety function has been triggered.
4 Stop the vacuum cleaner. Check that nothing is obstructing the rotation of the brush; if there is an
obstruction, remove it and clean the power-brush, then turn on the vacuum cleaner.
Your vacuum cleaner is not vacuuming as well, is making noise, whistling:
- The intake channel is partially blocked.
4 Unblock it
- The dust collector is full.
Empty it and clean it.
- The dust collector is not properly tted.
4 Re-position it correctly.
- The intake head is clogged.
4 Remove the power-brush and clean it.
- The protective foam lter is saturated.
4 Clean it.
EN
5.
RG74XX
Serial No. Error Error description
1 Left wheel error Left wheel is not working, overload in left wheel.
Indicator POWER ashes twice and beeps once.
2 Right wheel error Right wheel is not working, overload in left wheel.
Indicator POWER ashes 3 times and beeps once.
3 robot lifted error The robot is lifted over 1 second.
Indicator POWER ashes 4 times and beeps once.
4 Front wheel error Front wheel is not working, is stucked.
Indicator POWER ashes 5 times and beeps once.
5 Cli sensors error Cli sensors are not working.
Indicator POWER ashes 6 times and beeps once.
6 Low battery error POWER is going to be dead.
Indicator POWER ashes 7 times and beeps once.
7 Front bumper error Switch on the left or right side of bumper is not restored.
Indicator POWER ashes 8 times and beeps once.
8 Middel brush error Main brush is not working, overload.
Indicator DOCKING ashes 2 times and beeps once.
9 Side brush error Side brush is not working, overload.
Indicator DOCKING ashes 3 times and beeps once.
10 Wall sensor error Wall sensor error.
Indicator DOCKING ashes 4 times and beep once.
11 Fan motor error Fan motor is not working, overload.
Indicator DOCKING ashes 5 times and beeps once.
12 No dustbin error No dustbin.
Indicator DOCKING ashes 6 times and beeps once.
13 Charging error Robot is not well connnected to the docking station.
Indicator DOCKING ashes 7 times and beeps once.
Please keep this user manual.
Страницы: Стр: 22
Комментарии (0)

Добавить комментарий

Другие Пылесосы Tefal