-11-
User’s Guide
Filter Element Replacement Cycle
After using the product cartridge for a period of time, it will accumulate various
impurities in the cartridge, affecting the water speed. In order to maintain normal
water output, the cartridge should be replaced regularly.
The recommended replacement cycle of filter element is not a quality assurance
period, but an ideal filter element replacement cycle based on raw water conform-
ing to the national standard for drinking water and normal water used by ordinary
families;
The recommended replacement cycle of the filter element is the expected period,
and the actual use cycle may vary due to different regions, water quality, usage
and seasons. Therefore, the above suggested replacement cycle of the filter
element is for reference only, and the suggestions of the local distribution service
outlets shall prevail.
If the following situations occur, you should also consider replacing the filter
element:
1. The effluent water quality is poor, the taste is not good, and the effluent TDS
value increases significantly;
2. The water flow rate is significantly reduced. If it is not due to the environmental
temperature and low water temperature, it is necessary to check whether the filter
element or film is blocked, or consider replacing the filter element;
3. If it is found that the surface of the filter element is seriously discolored, or the
outer surface has been covered by dirt;
4. The filter element is seriously blocked, and the water is slow or no water.
In order to ensure that each filter element of the product plays a good filtering
effect and ensure that the water meets the drinking standard, users should replace
or clean the filter element regularly. When the user replaces the filter element, the
filter element should be replaced by professional water treatment installation and
maintenance personnel.
1. Close the inlet ball valve, turn off the water purifier power supply, and open the
tap to discharge water until no water flows out;
2. Remove the front panel of the machine, hold the handle of the filter element,
rotate the filter element counterclockwise, and remove the filter element to be
replaced;
3. Take a new filter element, insert the new filter element into the machine
according to the instructions of the body, and screw the filter element into place in
a clockwise direction;
4. Open the inlet ball valve, switch on the power supply of the purifier, and wash
the filter element according to the steps in "How to Use" on page 9;
5. Refer to "Filter element life reset mode" on page 10 for life reset of the replaced
filter element.
Filter Element Replacement Method
Pre/Post composite filter element
(PCB)
(24~36)months
Reverse osmosis
membrane element (RO)
(6~12)months
Recommended
replacement cycle
Type of filter
element
Добавить комментарий