
21
13. Do not remove the plug from the outlet by the wire: this is very dangerous.
14. Do not move the appliance close to the mains plug.
15. If the power cord is damaged, it should be replaced with a special cord or kit provided by an authorized service center. Cable replacement should only
be carried out by qualified personnel. Connect the device to an electrical outlett that has a serviceable protection device (circuit breakers,fuses,ect.).
16. Do not touch the internal cooling surfaces of the refrigerator.
17. Disconnect the refrigerator from the mains before performing any cleaning or maintenance operations. Setting the thermostat knob to the
«ВЫКЛ»(OFF) not enough to ensure electrical safety.
18. It is prohibited to change the design of the refrigerator and the intervention of persons not authorized by the manufacturer for warranty repairs.
19. Do not use electrical appliances inside the food storage compartment unless recommended by the manufacturer.
20. Do not store flammable gases or liquids inside the refrigerator.
21. Do not store glass bottles and cans of liquid in the freezer.
22. Should You decide to transfer the appliance to another person, please pass the present manual over along with it.
OPERATING RECOMMENDATIONS
- Do not connect too many appliances to the same power supply circuit, as this may cause a fire.
- If you do not plan to use the refrigerator for a long time, disconnect its power plug from the outlet.
- Do not touch the inner walls of the low-temperature compartment or the products lying in it with wet hands.
- Do not put bottles or other glass vessels in the low-temperature compartment.
WARNING!
- Cooling in the refrigerator is provided by a refrigerant that is filled into the refrigerator using special equipment. Do not damage the refrigerant
circulation tubes on the back of the refrigerator.
- This product contains a small amount of refrigerant, which is isobutane, a natural gas that does not harm the environment, but is flammable. When
transporting and installing the refrigerator, care must be taken not to damage any parts of the refrigerant circuit.
- Coming out of the tubes, the refrigerant can ignite or harm your health. If damage to the refrigerant circuit does occur, avoid any kind of open fire or
potential sources of ignition, and ventilate the room where the refrigerator is located for a few minutes.
- In order to avoid the formation of a flammable mixture of gas and air in the event of a refrigerant leak, the dimensions of the room where the
refrigerator is located must correspond to the amount of refrigerant used in the refrigerator.
- The volume of the room should be 1 m3 for every 8 g of refrigerant R600a in the refrigerator. The amount of refrigerant contained in your particular
refrigerator is indicated on
- the nameplate on the back of the refrigerator.
- Never turn on the refrigerator with signs of damage. If you have any doubts about the serviceability of the product, contact customer service.
2. PACKAGE CONTENTS
СТ-1700
- Refrigerator - 1 pc.
- User manual - 1 pc.
- Water collection tray - 1 pc.
- Lattice shelf - 1 pc.
- Plug - 3 pcs.
СТ-1702
- Refrigerator - 1 pc.
- User manual - 1 pc.
- Water collection tray - 1 pc.
- Lattice shelf - 2 pcs.
- Ice cube tray - 1 pc.
- Egg tray - 1 pc.
СТ-1703
- Refrigerator - 1 pc.
- User manual - 1 pc.
- Water collection tray - 1 pc.
- Lattice shelf - 2 pcs.
- Glass shelf - 1 pc.
- Container for vegetables - 1 pc.
- Ice cube tray - 1 pc.
- Egg tray - 1 pc.
3. REFRIGERATOR TRANSPORTATION
When transporting or carrying the device, hold it by the bottom and carry it in an upright position. Do not tilt the refrigerator more than 450 degrees.
Never turn it upside down. Do not place the appliance on the sides or back. Do not transport the device if it is lying on its side, on the back or on the
front sides. Do not use the door as a carrying aid. This can disable the device. The two rear legs of the refrigerator are equipped with rollers. To move
around the kitchen and accurately install the appliance in place, tilt the refrigerator slightly in the direction of the back wall and move it. The two
front legs of the refrigerator can be adjusted in height. In order to align the device precisely, twist the front legs to the left or right so that the device
is securely on the floor.
After transporting and installing the refrigerator, wait about three hours before connecting it to the mains to be sure that the refrigerant has been
properly distributed after transportation - this is necessary for the refrigerator to work properly.
1. Freezer compartment
2. Latch
3. Metal grating shelf
4. Adjustable legs
5. Temperature controller
6. Door shelf
7. The door
8. Bottle shelf
1. Freezer compartment
2. Metal grating shelves
3. Adjustable legs
4. Temperature controller
5. Door shelf
6. The door
7. Bottle shelf
1. Freezer compartment
2. Main shelves
3. Vegetable container
4. Mounting points of the adjustable support (depending on the position of the mounted door)
5. Temperature controller
6. Door shelves
7. The door
8. Bottle shelf
Добавить комментарий