Centek CT-1702

Данная инструкция на русском языке предназначена для холодильника Centek CT-1702, описывает принцип работы и основные моменты эксплуатации устройства. Перед первым включением рекомендуется внимательно изучить данное руководство.

Инструкция для холодильника представлена в формате PDF, который поддерживается на всех современных устройствах, так что сложностей с открытием файла возникнуть не должно. Но если открыть документ не получается, установите любую программу для чтения PDF файлов, например Acrobat Reader.

Чтобы распечатать инструкцию, нужно ее сначала скачать, для этого кликните по кнопке «Скачать инструкцию», файл откроется в новой вкладке, затем нажмите комбинацию клавиш Сtrl + P и из открывшегося диалогового окна, отправьте документ на печать.

Страницы: Стр:
23
4. They contain tightly sealed effervescent or carbonated drinks. The liquid, crystallizing, can destroy the container.
5. Do not put liquids in containers without a lid in the freezer, in order to avoid an increase in humidity, because this leads to an increase in temperature.
6. MAINTENANCE AND CARE
To defrost the refrigerator, put the thermostat knob in the «0» and disconnect the refrigerator from the power supply. At the time of defrosting, wrap the frozen
products in several layers and place them, if possible, in a cold place. Wash and dry the refrigerator compartment thoroughly before turning it on again.
If a layer of frost with a thickness of more than 5 mm has formed in the freezer during operation, it should be prepared for defrosting. To do this, remove
the products from it and place them on the shelves of the refrigerator. Next, leave the freezer door open and install any container for collecting melt
water, then wash the freezer and wipe dry.
Always store strong-smelling products in tightly closed containers to avoid the formation of odors that will be difficult to remove later.
Wash the inside and outside surfaces of the refrigerator with a sponge or a soft cloth. Use neutral detergents. Never use powder abrasive detergents,
alkaline compounds, organic acids and hot water, this can damage the paintwork. Do not use sharp or metal objects, it may damage the refrigerator.
All removable parts can be washed with a solution of soap or detergent in water. They can also be washed in the dishwasher. Remember that all
removable parts must be thoroughly dried before putting them back in the refrigerator.
Dust can accumulate on the refrigerator condenser and interfere with its normal operation.
Carefully vacuum the back of the refrigerator using suitable nozzles.
If you are not going to use the refrigerator for a long time, disconnect it from the power supply, wash it inside, dry it and leave the doors ajar to avoid
the formation of unpleasant odors and mold.
RECOMMENDATIONS FOR SAVING ELECTRICITY
Install the refrigerator correctly
At a sufficient distance from heat sources,in a well-ventillated room,in accordance with the recommendations of the REFRIGERATOR INSTALLATION point.
Set the temperature correctly
Set the thermostat to the middle position. Setting an excessively low temperature will only affect the increase in electricity consumption, but will not
improve the safety of products.
Do not overfill the refrigerator
Sufficient air circulation is important for the safety of products. Overfilling with food interferes with free air circulation, proper operation of the
refrigerator and causes additional electricity consumption.
Keep the door closed
Open the doors only if necessary, remember that each opening of the door slightly increases the temperature inside the refrigerator and electricity is
consumed to restore the previous temperature. Make sure that the sealing rubber on the refrigerator doors remains clean and fits snugly to the case
when closed, this will avoid leakage of cold air.
Do not place hot food
Hot foods placed in the refrigerator immediately raise the temperature by several degrees. Let the food and dishes cool to room temperature, then put
them in the refrigerator.
7. TROUBLESHOOTING
In case of unsatisfactory operation of the refrigerator or malfunction, study this section before contacting an authorized service center. In some cases,
you can fix the problems yourself.
THE REFRIGERATOR IS NOT WORKING
Check that:
- The electricity is not turned off in the house;
- The plug is securely inserted into the socket;
- The socket is working properly.
THE TEMPERATURE IN THE REFRIGERATOR IS TOO HIGH
Check, that:
- The door is closed tightly, the seal is not damaged;
- The thermostat knob is in the correct position;
- The shelves are not overfulliing with products;
- The door was not opened often.
THE COMPRESSOR IS CONSTANTLY RUNNING
Check, that:
- The refrigerator door closes tightly and does not open too often;
- The room temperature is not too high;
- The thermostat knob is in the correct position.
THE REFRIGERATOR IS TOO NOISY WHEN WORKING
Check that:
The refrigerator is not aligned;
The refrigerator touches foreign objects (for example, surrounding furniture).
The refrigerant circulating inside the cooling system can cause the sound of overflowing liquid, even if the compressor is not working. This is not a
malfunction and does not affect the efficient operation of the refrigerator.
The characteristic sounds of switching on the thermostat and compressor are normal sounds that occur during the operation of the electrical equipment
of the device.
If the refrigerator does not work properly after checking, contact an authorized service center.
Страницы: Стр: 24
Комментарии (0)

Добавить комментарий

Другие Холодильники Centek