Hiberg i-DDQ6 - 612 G

Данная инструкция на русском языке предназначена для стиральной машины Hiberg i-DDQ6 - 612 G, описывает принцип работы и основные моменты эксплуатации устройства. Перед первым включением рекомендуется внимательно изучить данное руководство.

Инструкция для стиральной машины представлена в формате PDF, который поддерживается на всех современных устройствах, так что сложностей с открытием файла возникнуть не должно. Но если открыть документ не получается, установите любую программу для чтения PDF файлов, например Acrobat Reader.

Чтобы распечатать инструкцию, нужно ее сначала скачать, для этого кликните по кнопке «Скачать инструкцию», файл откроется в новой вкладке, затем нажмите комбинацию клавиш Сtrl + P и из открывшегося диалогового окна, отправьте документ на печать.

Страницы: Стр:
51www.hiberg.ru
LEVELING THE WASHER
Importance of leveling the washer
The washer uses high spin speeds to remove water at the end of the wash
cycle. It is important that the washer is level and that the washer feet press with
equal pressure against the floor. This will help assure the quietest, most vibration-
free use of the washer.
Follow these steps:
1. Install the washer on a level and solid surfaces. Preferably in a corner of a room.
2. If the floor is uneven (or out of level ) adjust the washer feet as required to
level the washer. Do not place anything under the washer feet to help level the
washer.
3. Extend the washer feet no more than is necessary. The more the feet are
extended, the more vibration the washer will experience. Start with the washer
feet turned all the way in and adjust each foot as necessary.
4. Use a bubble level (no supplied) to check the top of the washer to make sure it
is level side to side and front to rear.
5. Press down on each corner of the washer top to make sure the washer doesn’t
«wobble». There should be no «give» or movement. All the washer feet should
press equally against the floor. This is just as important as the washer being
level to prevent vibration.
6. When the washer is level and does not wobble, lock the washer feet in place by
tightening the locknuts against the washer bottom. Be sure to do this without
changing the height of the foot (hold the foot while tightening the locknut).
(a) 3 cm or more above.
(b) 5 cm or more behind.
(c) 2 cm or more on the left side.
(d) 2 cm or more on the right side.
(e) 64 cm or more.
CAUTION: do not let metallic portions
of the washer come into contact with
metal sinks or other appliances.
Set-in Installation
Install the washer with easy access to the power plug and socket.
Install the washer where there is enough space around it.
Страницы: Стр: 49
Комментарии (0)

Добавить комментарий

Другие Стиральные машины Hiberg