Centek CT-1723
Данная инструкция на русском языке предназначена для холодильника Centek CT-1723, описывает принцип работы и основные моменты эксплуатации устройства. Перед первым включением рекомендуется внимательно изучить данное руководство.
Инструкция для холодильника представлена в формате PDF, который поддерживается на всех современных устройствах, так что сложностей с открытием файла возникнуть не должно. Но если открыть документ не получается, установите любую программу для чтения PDF файлов, например Acrobat Reader.
Чтобы распечатать инструкцию, нужно ее сначала скачать, для этого кликните по кнопке «Скачать инструкцию», файл откроется в новой вкладке, затем нажмите комбинацию клавиш Сtrl + P и из открывшегося диалогового окна, отправьте документ на печать.
27
A few hours after connecting the refrigerator to the mains, You
can put products in it.
Remove the transport spacers between the compressor and the
back wall of the niche, as well as other spacers and adhesive
tapes that keep the moving parts of the device from shifting.
If the device has a protective coating of polymer film, carefully
remove it, taking precautions not to damage the paint or polymer
coating of the parts.
DISPLAY
1
2
3
B
A
C
1. Display screen
2. Temperature increase button
3. Temperature reduction button
A. Cooling indicator
B. Temperature value or error code
indicator
C. Super Cool mode indicator
• When you turn on the refrigerator for
the first time, the display will light up
for 3 seconds. The display then goes into
standby mode.
When you use the refrigerator for the
first time, the default refrigerator
compartment temperature is 5 °C.
• When an error occurs, an error code
appears on the display screen. If there
are no errors, the temperature value
appears on the display screen.
TEMPERATURE SETTING
Press the temperature increase button to adjust the
temperature. Each time you press the button, the value will
increase by 1 °C. Press the temperature reduction button to
adjust the temperature. Each time you press the button, the value
will decrease by 1 °C. The refrigerator compartment temperature
setting range is 2~8°C. When the temperature reaches the limit
value, the refrigerator will beep if you continue to press the
buttons. While the refrigerator compartment is cooling, the
indicator (A) on the display screen will light up.
MODE SELECTION
• Setting the super cool mode: After the refrigerator compartment
temperature reaches 2 °C, press the temperature down button
to enter the super cool mode. The mode indicator (C) will light
up on the display screen. In Super Cool mode, the temperature
of the refrigerator compartment is automatically set to 2 °C.
• Exiting super cool mode: Press the temperature increase button
to exit super cool mode, otherwise it will exit super cool mode
automatically after 6 hours. After exiting Super Cool mode,
the refrigerator temperature will automatically return to the
temperature set before Super Cool mode. The mode indicator
(C) will go out.
DOOR OPEN SIGNAL
If the door is not closed within two minutes, an alarm will sound.
To turn off the signal, close the refrigerator door or press any
button.
USING THE FREEZER
NORMAL
COLDERCOLD
(summer) (winter)
Freezer
Control
The freezer temperature control is located at the bottom of
the refrigerator compartment, behind the bottom «zero zone»
container.
Using the temperature controller, you can select the mode in
accordance with the requirements:
«COLD» - the mode of increased freezing. It is used in summer
time, or at an ambient temperature above 35 °C.
«COLDER» - reduced freezing mode. It is used in winter time, or at
an ambient temperature below 10 °C.
«NORMAL» - the average value between the «COLD» and
«COLDER» modes. Typically used at ambient room temperature.
In order to ensure the best storage conditions for products, follow
the recommendations below. Products intended for freezing and
storage in the freezer should be carefully packed to avoid the
formation of excessive frost.
–Preferably, the products placed inside the freezer should not
come into contact with the back and side walls.
–For proper storage and ease of subsequent defrosting, place the
products in small portions.
–Do not place full glass containers with freezing liquids in the
freezer for a long time, especially if.
–They contain tightly sealed effervescent or carbonated drinks.
The liquid, crystallizing, can destroy the container.
–Do not put liquids in containers without a lid in the freezer, in
order to avoid an increase in humidity, because this leads to an
increase in temperature.
6. MAINTENANCE AND CARE
When cleaning or maintaining the refrigerator, first turn off the
power by removing the plug from the socket. Empty the chambers
of food. Use neutral detergents. Never use abrasive detergents,
alkaline products, organic acids and hot water as this may
damage the paintwork. Do not use sharp or metal objects as this
may damage the refrigerator.
The door seal gets dirty easily and needs to be washed more often.
If you do not use the refrigerator for a long time, remove the plug
from the socket, defrost, wash and dry the refrigerator.
7.TROUBLESHOOTING
In case of unsatisfactory operation of the refrigerator or
malfunction, study this section before contacting an authorized
service center. In some cases, you can fix the problems yourself.
Комментарии (0)
Другие Холодильники Centek
Добавить комментарий